WATER SOFTENER DUO TAC TAC NEXT SCALE STOP NSS-110B-D

Dedurizator fara sare Duo TAC Next Scale Stop NSS-110B-D, uses salt-free technology called Template Assisted Crystallization.

Tested and verified!

Tested by independent laboratory to prevent deposits, The TAC Next Scale Stop has a 99.6% rating for deposit prevention, the only technology to achieve this performance, being more effective than any other alternative.

TAC certifications, Next Scale Stop: NSF standard 61

          
Recommended for a continuous flow of: 10 l/minute and for peak flows up to 15 l/minute.

Maximum recommended hardness: 72.8 German degrees

Note: tehnologia TAC nu functioneaza ca un dedurizator clasic, prin schimb ionic si prin inlocuirea din apa a sarurilor de calciu si de magneziu cu sodiu. Din acest punct de vedere, ar trebui numit decalcificator sau mai corect conditionator. Deci, aveti in vedere faptul ca nu este un dedurizator traditional si ca ionii de calciu si de magneziu raman in apa dar sub o forma care stopeaza depunerile. Deci, duritatea apei va ramane aceeasi, inainte de tratare si dupa tratare.

Dedurizatorul Duo TAC Next Scale Stop NSS-110B-D – previne depunerile in instalatii si protejeaza echipamentele. In plus, filtreaza apa la un grad de 5 microni. 

Limescale deposits in the plumbing, block pipes, faucets, destroy the central heating system and boiler. With TAC next NSS-110B, you will save money and have time for yourself, not time for repairs!

Dedurizatorul Duo TAC Next Scale Stop NSS-110B-D - By using TAC technology, you remove existing deposits in installations and considerably extend the life of water-using equipment. If you have used untreated hard water, deposits have formed in the installations. Using TAC technology will gradually clean the installation. The classic water softener cannot do this!

No chemicals needed - green - environmentally friendly!
The classic softener uses salt for regeneration, which is not at all economical and environmentally friendly, as this brine has to be discharged to the sewer after the regeneration process.

It's 100% environmentally friendly and economical without buying salt. Because Dedurizatorul Duo TAC Next Scale Stop NSS-110B-D not using salt, you'll save money that you can use for anything else.

Minimum maintenance and low costs
Classical softening plants contain electronic or mechanical control valves that need maintenance and periodic cleaning. This requires specialists, which means costs for you. Dedurizatorul Duo TAC Next Scale Stop NSS-110B-D contains no moving parts so absolutely nothing can wear.

No electricity - installed anywhere
Dedurizatorul Duo TAC Next Scale Stop NSS-110B-D, it doesn't use electricity, and it doesn't discharge water to the sewer. So it can be installed anywhere!

Cost savings
Dedurizatorul Duo TAC Next Scale Stop NSS-110B-D – it pays for itself in time, because you no longer buy salt, you no longer use electricity, you no longer pour water into the sewer, pumped by electricity or paid to the water authority!

Did you know that 1 mm of limescale in your boiler or central heating system reduces the heating output by 10%? And this deposition occurs in less than a year! And in three years it will reduce the heating output by up to 241TP33T!

Replacement parts
Pentru ca nimic in aceasta lume nu dureaza la infinit, cartusele filtrante trebuie schimbate. 

Filtre incluse in modelul Duo TAC Next Scale Stop NSS-110B-D:

• 5 micron - pressed polypropylene fibers - for filtering sediment, silt, silt, sand, rust;
• TAC anti-scaling TAC

Installation conditions:

- will be installed at the entrance of the house on the main cold water pipe;
- if there is more than one treatment/filtration equipment, install the last one in the filtration scheme;
- to be installed before any domestic or heating equipment, which is intended to be protected from limescale;
- if the installation is made of copper, the water will be used for four weeks before it is treated and run through the Dedurizatorul Duo TAC Next Scale Stop NSS-110B-D. Tehnologia TAC nu are voie sa intre in contact cu cuprul. Dupa utilizare timp de patru saptamani, conductele de cupru vor fi pasivizate, iar acest lucru va impiedica ca ioni de cupru sa ajunga in mediul filtrant TAC;
- we recommend the installation of a bypass, consisting of pipes and three valves, in case of service or change of filter medium.

Water quality because dedurizatorul Duo TAC Next Scale Stop NSS-110B-D sa poata fi utilizat cu succes.

Feed water/treatment water must meet the following conditions:

pH 6.5 - 8.5
Maximum hardness - 72.8 German degrees
Presiune min/max – 1-5 bari (recomandam utilizarea cu o presiune max. de 4.5 bari)
Temperature - 5°C to 43°C
Chlorine - < 3ppm
Iron (maximum) - 0.3 mg/l
Manganese (maximum) - 0.05 mg/l
Copper - 1.3 mg/l
Oil/petrol and hydrogen sulphide - not allowed
Polyphosphate - not allowed
Silicon (maximum) - 10 ppm

If the water is from a controlled source (waterworks) and meets drinking water standards, it is not necessary to carry out a water analysis.

Technical specifications:
Connections: 1″ IN/OUT;
Lungime: 42 cm
Height: 47 cm;
Latime: 20 cm.

Maintenance:

Primul cartus se va schimba la fiecare 3 – 6 luni

The filter cartridge for anti-scale treatment will be changed every 2 years.

2-year guarantee

Assembled in Romania. We use TAC Next Scale Stop (UK).